GE researching and developing lower cost wind turbine technology

December 31st, 2012 by GE Global Research

A section of a wind turbine blade depicts a new manufacturing concept that would entail covering the blade with a tensioned fabric. This approach could significantly reduce production costs and make wind energy more economical (click image to expand - image courtesy of GE Global Research)

GE, Virginia Polytechnic Institute & State University (Virginia Tech), and the National Renewable Energy Laboratory (NREL), will begin work on a project that could fundamentally change the way wind blades are designed, manufactured and installed.

With most of the cost of electricity from wind energy tied up in the initial capital investments made in the wind turbines themselves, new technology advancements that reduce these costs could substantially lower the overall cost of wind power.

“GE’s weaving an advanced wind blade that could be the fabric of our clean energy future,” said Dr Wendy Lin, a GE Principal Engineer and leader on the U.S. Department of Energy’s Advanced Research Projects Agency (ARPA-E) project.

“The fabric we are developing will be tough, flexible, and easier to assemble and maintain. It represents a clear path to making wind energy even more cost competitive with fossil fuels,” Dr Lin said.

According to GE, this new blade design could reduce blade costs 25% to 40%, making wind energy as economical as fossil fuels without government subsidies.

GE’s research will focus on the use of architectural fabrics, which would be wrapped around a metal spaceframe, resembling a fishbone.

Fabric would be tensioned around ribs which run the length of the turbine blade and specially designed to meet the demands of wind blade operations.

Conventional wind blades are constructed out of fibreglass, which is heavier and more labour, and time-intensive to manufacture.

Advancements in blade technology will help spur the development of larger, lighter turbines that can capture more wind at lower wind speeds.

Current technology doesn’t easily allow for construction of turbines that have rotor diameters exceeding 120 metres because of design, manufacturing, assembly, and transportation constraints.

Wider, longer wind blades are tougher to move and manoeuvre, and moulds which form the clamshell fiberglass structure cost millions of dollars to acquire.

GE’s new fabric-based technology would all but eliminate these barriers.

With this new approach to making wind turbine blades, components could be built and assembled on site, meaning design engineers no longer have to concern themselves with manufacturing and transportation limitations.

Taken together, these improvements will help reduce start-up costs and the cost of wind-generated electricity in general.

It is estimated that to achieve the US national goal of 20% wind power, wind turbine blades would need to grow by 50% – a figure that would be virtually impossible to realise given the size constraints imposed by current technology.

Lighter fabric blades could make this goal attainable.

“Developing larger wind blades is the key to expanding wind energy into areas we wouldn’t think of today as suitable for harvesting wind power.

Tapping into moderate wind speed markets will only help grow the industry in the years to come,” Dr Lin said.

The use of fabrics to reduce weight and provide a cost-effective cover dates back to the World War I era, when it was used on airplanes.

Over the years fabric has proved to be rugged and reliable and GE has already begun using this spaceframe/tension fabric design in the construction of wind towers for better aesthetics, cost, and protection.

The $5.6 million ARPA-E project will span three years.

GE’s blade architecture will be built to achieve a 20 year life with no regular maintenance to tension fabrics required.

 

  1. No Comments

Have your say